Siren Test
Dial Out Menu
Allow Engineer Menu
Block UDL Set
SIREN TEST?
Testing Siren...
This function is used to test the siren and strobe outputs.
Press b or h to scroll to ‘SIREN TEST’. Press f.
This tests both the siren and strobe outputs. Press f
to end the test.
This function is used to force the panel to dial out to UDL software.
Do not use this function unless you have been instructed to by your engineer.
ALLOW ENGR MENU?
BLOCK UDL
SET?
Allow Engr Menu?
Yes [1]
Block UDL Set
No [0]
Press the b or h keys to scroll to ‘ALLOW
ENGINEER MENU’. Press f.
Press b or d to select either ‘Yes’ or ‘No’. Press
f.
If this function is set to ‘No’, the engineer will require authorisation from you (by changing it back to
‘Yes’ before they can access the engineer menu).
Your alarm installation company may have configured your alarm system so it can remotely be set/
unset via UDL software. Should you wish to block this access, you can enable this function.
Press the b or h keys to scroll to ‘BLOCK UDL
SET’. Press f.
Press b or d to select either ‘Yes’ or ‘No’. Press
f.
To Next Page
Loading...
