45
Network Troubleshooting.
Check that the network cable is properly connected to
the LAN port on the back of your NVR and to a network
port on your router. The lights on both ports should blink
occasionally to indicate that data is being transmitted.
If the cable is properly connected, but no data is
transmitting, replace the cable or try another port on the
router.
Your NVR must be connected directly to the router and
not through a network hub or switch.
Your router must have DHCP enabled. Consult your
router’s manual to determine if it has this feature and
how to enable it. If your router is provided by your
Internet Service Provider (ISP), consult their tech support.
Troubleshooting
To Next Page
Loading...
