Q-See QT SERIES Manual

42
Wizard Glossary
DST (Daylight Savings Time): Set DST to change where applicable. Click
“Set” to enter the start and end dates. Make sure the box is checked.
NTP (Network Time Protocol): This maintains the accuracy
of the NVR’s clock. Check the box to turn on.
Language: This is the language the NVR will use.
Local IP Address (LAN): The NVR’s address on your local network.
IP: Internet Protocol. IP devices communicate with each
other via a local network or over the Internet.
POE: Power Over Ethernet. Uses a standard Ethernet cable to transmit power
and commands to the camera while receiving video back from it.
NVR: Network Video Recorder. Work with IP cameras connected to it directly or over a network.
Resources / Appendix

Q-See QT SERIES Specifications

General

Series	QT Series
Video Compression	H.264
Remote Viewing	Yes
HDMI Output	Yes
VGA Output	Yes
Motion Detection	Yes
Channels	4, 8, 16
Recording Resolution	1080p, 720p
Hard Drive Capacity	Up to 6TB
Mobile App Support	Yes
Network Connectivity	Ethernet