To Next Page

To Previous Page

3.4 Rear panel

1. DC in 5V connector: Connect to the supplied AC adaptor.

2. Reset (reboot) button: Press this button with a pen or a

pin to reboot the uPlay Stream.

3. LAN indicator: This LED will turn on when the uPlay

Stream is connected to a router via an Ethernet cable.

4. LAN port: Connect to a router via an Ethernet cable.

5. WPS button: This button serves two functions:

• Press and hold the WPS button for 2 seconds, then

release the button for WPS function.

• Press and hold the WPS button for more than 8

seconds, then release the button for factory reset

function.

6. 3.5mm stereo audio output jack: Connect to an amplifier

or powered speakers.

3.5 Top panel LED indications

1. Power LED: This LED will turn on when the uPlay Stream

is powered on.

2. WiFi activity LED: This LED will turn on after power on. It

will blink when there is WiFi activity.

3. WiFi connection LED:

•LEDoff:NoWiFiconnectionorconnectionerror.

•LEDblinking:WiFiconnecting.

•LEDon:WiFiconnected.

1234 56

123

Other manuals for QED uPlay Stream

Questions and Answers:

Need help?

Do you have a question about the QED uPlay Stream and is the answer not in the manual?

General