Enable “EN Grade 2” Setting
By enabling “EN Grade 2” setting, the following parameters will be changed automatically.
-
Entry Procedure (EU) - Follows entry procedures and alarm transmission delays specified by EN 50131-1 standards section 8.38
-
Enables arming protest feature when trouble conditions are present. The user must override any troubles in order to arm the system.
-
Trouble conditions will remain present until a user has acknowledged them.
-
Trouble beeps are expanded to include fault indications required by EN 50131-1 section 8.5.2
-
Screen will automatically lock 30 seconds after disarming the system.
-
EU Event history buffer - Found in the basic settings menus, EU Events will record mandatory history events specified by EN 50131-1
section 8.10
-
Enables “EU Event Swinger Shutdown Count” - setting to change the count to 3 events allowed for any individual event during an
arming cycle
-
“Auto Bypass” setting is not available
-
“Partitions” setting is not available
-
Panel allows 5 incorrect user code attempts and then locks access for 90 seconds
The installer must be responsible for settings the rest of the following parameters in order to be EN 50131-1 compliant:
-
Enable “Screen Lock” settings
-
Set “Loss of Supervisory Signals for PowerG non-emergency sensors” to 20 minutes
-
Set “Normal Entry Delay” to maximum 45 seconds
-
Set Trouble Beeps Timeout to 3 minutes
-
Enable “PowerG RF Jam” EN 30/60
-
Set “Dialer Delay” must remain at 30 seconds
-
Disable “LED Indicator”
-
Disable “Fire Panic” and “Auxiliary Panic”
-
Enable 6 digit access codes
-
“Voice Prompt” needs to be disabled for the security sensors for EN compliant installations
User must enable “Dealer or Installer Access Requires User Permission
To Next Page
Loading...
