INSTALLER/DEALER SETTINGS
Choose whether or not you want the “Thermostat Page” to appear as part of primary user
interface on the panel anytime a Thermostat is added as a device.
When enabled, a new icon will appear in the panel UI on left hand footer enabling the
use of Scenes that have been created on Alarm.com. NOTE: This feature can not be enabled if
Partitions are enabled.
This setting allows the built-in Panel Camera to act as an IP Camera. When Enabled, the
Panel Camera will show up in Alarm.com as a camera that can be added to the account.
NOTE: This feature can not be Enabled if Panel Motion Detector is Enabled.
Stream Live Video Cameras to IQ
Remote
This setting allows a user to view cameras from the IQ Remote. When enabled, Cameras
that are streaming to the primary panel will also stream to the IQ Remote.
When enabled the system can detect when an unusual amount of RF signals are being
transmitted in the PowerG spectrum leading to a potential panel malfunction. This event
reports to the central station when enabled. Choose from Disabled, UL20/20 or En
30/60.
When enabled the system can detect when an unusual amount of RF signals are being
transmitted on the frequency of the legacy daughter card installed in the panel
(319.5MHz, 345MHz or 433MHz) leading to a potential panel malfunction. This event
reports to the central station when enabled. Not evaluated for CE/EN Grade 2.
QOLSYS CONFIDENTIAL AND PROPRIETARY
PAGE OF 33 173
To Next Page
Loading...
