www.qpcom.com/www.qpcom.com.co
VI. Wireless Security Setup
This page is used to configure wireless security.
Operation Mode
This page is used to configure which mode wireless broadband router acts.
This page allows you setup the wireless security. Turn on WEP or WPA by using Encryption. Keys
could preventing unauthorized access to your wireless network
Encryption:
Key Length:
Key Formal:
Key Setting:
6. Wireless Security Setup
Next >>
<< BackCancel
WEP
64-bit
Hex (10characters)
**********
You can setup different modes to LAN and WLAN interface for NAT and bridging function.
Operarion Mode
Apply Changes Reset
Gateway:
Bridge:
Wireless ISP:
In the mode, the divice is supposed to connect to internet via ADSL Cable
Modem. The NAT is enabled and PCs in four. LAN ports share the same IP to
ISP through WAN port. The conection type can be setup in WAN page by
using PPPOE, DHCP client, PPTP client, L2TP cliente or static IP.
In the mode, all ethernet ports and the wireless interface are bridged and
NAT function is disabled. All the WAN related function and firewall are not
supported.
In the mode, all ethernet ports are bridged together and wireless client will
connect to IPS access point. The NAT is enable and PCs in ethernet ports
share the same IP to ISP through wireless LAN. You must set the wireless to
client mode first and connect to the ISP AP in Site-Survey page. The
connection type can be setup in WAN page by using PPPOE, DHCP client,
PPTP client, L2TP client or static IP:
To Next Page
Loading...
Need help?
General