What is Inter-Access Point Protocol (IAPP)?
The IEEE 802.11f Inter-Access Point Protocol (IAPP) supports Access Point Vendor interope-
rability, enabling roaming of 802.11 Stations within IP subnet.
IAPP defines messages and data to be exchanged between Access Points and between the
IAPP and high layer management entities to support roaming. The IAPP protocol uses TCP for
inter-Access Point communication and UDP for RADIUS request/response exchanges. It also
uses Layer 2 frames to update the forwarding tables of Layer 2 devices.
What is Wireless Distribution System (WDS)?
The Wireless Distribution System feature allows WLAN AP to talk directly to other APs via
wireless channel, like the wireless bridge or repeater service.
What is Universal Plug and Play (uPNP)?
UPnP is an open networking architecture that consists of services, devices, and control points.
The ultimate goal is to allow data communication among all UPnP devices regardless of
media, operating system, programming language, and wired/wireless connection.
What is Maximum Transmission Unit (MTU) Size?
Maximum Transmission Unit (MTU) indicates the network stack of any packet is larger than
this value will be fragmented before the transmission. During the PPP negotiation, the peer of
the PPP connection will indicate its MRU and will be accepted. The actual MTU of the PPP
connection will be set to the smaller one of MTU and the peer’s MRU. The default is value
1400.
What is Clone MAC Address?
Clone MAC address is designed for your special application that request the clients to register
to a server machine with one identified MAC address. Since that all the clients will communica-
te outside world through the WLAN Broadband Router, so have the cloned MAC address set
on the WLAN Broadband Router will solve the issue.
What is DDNS?
DDNS is the abbreviation of Dynamic Domain Name Server. It is designed for user own the
DNS server with dynamic WAN IP address.
www.qpcom.com/www.qpcom.com.co
To Next Page
Loading...
Need help?
General