Clean and replace brushes
When dirty or saturated, clean the brushes of the envelope sealing or replace them as
follows:
Moisten the new brushes in water.1.
2. Remove the brushes one by one by pulling them down from the brush holder.
3. Replace the brushes. Make sure that the studs on the brushes are fitted in the
corresponding holes in the brush holder.
Replace or Clean Moistening Cloth
When dirty or saturated, clean the moistening cloth or replace if necessary. Proceed as
follows:
Open the front cover A.1.
2. Remove the sealing liquid reservoir B from the system.
9
English
121
| Page 121 | Nov-25-2020 04:16 | Operator Maintenance
To Next Page