Operation Page 47 of 85
2.10 Programming a Multi-Step Test
Paragraphs 2.4, 2.5, 2.6, 2.7 and 2.8 illustrate the programming of a 5-step test (GC, AC, DC, IR
& PA). To program a multiple step test, power-up the Sentry Plus Series instrument so the
‘Stand By’ display is shown (Figure 2-2). Press [F1] = PROGRAM and enter the test
parameters for the first test (GC). After specifying LOW resistance limit, press [F3] = NEXT and
[F1] = NEW to enter test parameters for the second test (AC). At this time, do NOT press [F4] =
EXIT because this will exit you from programming mode. After specifying FALL time for the
second test press [F3] = NEXT to continue entering test parameters for the third test (DC).
Continue this process for up to 10 steps. When finished entering desired number of test steps,
press [F4] = EXIT to exit programming mode and return to Stand By status.
In Stand By status, to view the test steps just programmed press [F4] = MORE. Figure 2-4
illustrates the Stand By display and resultant test steps display if the programming example in
paragraphs 2.4-2.8 was followed.
Figure 2-4: View Programmed Test Setups
EXIT
RMT ERROFSTLOCKSTAND BY
F1
F4
F3
F2
OUTPUT
0.1A
2.750kV
2.500kV
1.2
Ω
15.00mA
2.999mA
PROGRAM
PRESET
MORE..
MENU
RMT ERROFSTLOCKSTAND BY
0.1A
0.5s
1.2
Ω
F1
F4
F3
F2
LOWGC1/5M01 0.3
Ω
:
STAND BY
with
Memory ID
Test
Steps
M01
MEASURE RESULT
OFFSET
1
4
3
2
5
GC
AC
DC
IR
PA
0.750kV
OFF
1.5M
Ω
------------
------------
------------
------------
------------
Continuing with the 5-step example, press [F4] = MORE to view
the 5 test steps (GC, AC, DC, IR & PA) stored to location 1.
To Next Page
Loading...
Need help?
General
