Need help?Do you have a question about the Quantronix CUBISCAN 25 and is the answer not in the manual?
General| Brand | Quantronix |
|---|---|
| Model | CUBISCAN 25 |
| Category | Accessories |
| Language | English |
Troubleshoots errors occurring during the CubiScan 25 startup sequence.
Addresses issues with measurement accuracy and dimensional results.
Guides on diagnosing and resolving problems with gate movement.
Covers general or non-specific errors and their troubleshooting steps.
Details scale-related error messages and solutions.
Procedure for calibrating the CubiScan 25 scale using a test weight.
Instructions for cleaning the gate filters to maintain performance.
Procedure for safely removing and cleaning the glass platform.
Guide to safely cleaning the touchscreen surface.
Step-by-step guide to update the CubiScan 25 firmware using an SD card.
Procedure for firmware updates using a serial connection method.
Procedure to balance the four load cells for accurate weight readings.
Instructions for safely replacing a fuse in the CubiScan 25.
Guide to replacing the height transmitter board on the gate.
Steps to replace the width transmitter board located at the bottom of the gate.
Steps to replace the controller box located behind the touchscreen.
Procedure for replacing a CubiScan 25 load cell.
Instructions for replacing or adjusting carriage assemblies for gate movement.
Details pin assignments and parameters for serial RS-232 communication.
Shows pin assignments and default settings for Ethernet TCP/IP connection.
Details pin assignments for the USB 2.0 Type B connector.
Describes commands for cubing, weighing, setup, and communication.
To Next Page
