CubiScan 25 Service Manual 18
Chapter 3
Cleaning
This section describes the procedure used to clean the CubiScan 25. The CubiScan 25 should be
cleaned as often as needed to maintain optimum performance.
Cleaning the Gate Filters
This section describes how to clean the gate filters. While dust won’t normally interfere with
operation, they should be cleaned routinely to prevent the possibility of interference.
To clean the gate filters, use a clean, damp (if needed), microfiber cloth. Use water to dampen the
cloth; do not clean the gate filters with a solvent as this could cause damage.
Cleaning the Glass Platform
This section describes how to clean the glass platform.
To clean the glass platform, remove it from the CubiScan 25. Clean both sides of the platform
thoroughly with a clean, damp cloth.
If the glass platform is scratched it may interfere with measurements. Remove the glass platform
and try measuring. If this resolves the problem, you may need a new glass platform. Use your
spare glass platform. If you need to order a new platform, please contact Quantronix Technical
Assistance at +1 801-451-7000.
Cleaning the Touchscreen
This section describes how to clean the touchscreen.
To clean the touchscreen, moisten a soft cloth with water, then gently wipe the screen clean with
the cloth. Do not spray liquid directly on the touchscreen.
To Next Page
Loading...
Need help?
General
