Communication Protocol TCP/IP Communications Setup Command Set
CubiScan 25 Service Manual 85
Read Port
This command is used to read the current TCP Port number setting from the CubiScan 25.
18 1 Carriage Return Control (CR) 0Dh
19 1 Line Feed Control (LF) 0Ah
Acknowledge Format
1 1 Start of Text Control (STX) 02h
2 1 Set Command Alpha (@) 02h
3 1 MAC Address Command Alpha (M) 4Dh
4 1 Acknowledge Alpha (A) 41h
5 1 End of Text Control (ETX) 03h
6 1 Carriage Return Control (CR) 0Dh
7 1 Line Feed Control (LF) 0Ah
Negative Acknowledge Format
Pos Len Description Type Range ASCII
1 1 Start of Text Control (STX) 02h
2 1 Set Command Alpha (@) 40h
3 1 MAC Address Command Alpha (M) 4Dh
4 1 Neg. Acknowledge Alpha (N) 4Eh
5 1 End of Text Control (ETX) 03h
6 1 Carriage Return Control (CR) 0Dh
7 1 Line Feed Control (LF) 0Ah
Pos Len Description Type Range ASCII
Command Format
1 1 Start of Text Control (STX) 02h
2 1 Read Command Alpha (~) 7Eh
3 1 Port Command Alpha (P) 50h
41End of Text Control(ETX) 03h
5 1 Carriage Return Control (CR) 0Dh
6 1 Line Feed Control (LF) 0Ah
Acknowledge Format
1 1 Start of Text Control (STX) 02h
2 1 Read Command Alpha (~) 7Eh
3 1 Port Command Alpha (P) 50h
4 1 Acknowledge Alpha (A) 41h
Pos Len Description Type Range ASCII
To Next Page
Loading...
