Quectel BG96 - BG96 Storage, Manufacturing, and Packaging; Storage Conditions and Shelf Life

Section Parameter Definition
The default size is intended for devices sending small
message payloads. Increase this amount if you are using
devices that send large message payloads.
For large messages, you must ensure that the maximum NV store
size is at least four times the largest expected published message
size, plus eight bytes for the storage header. For example, for 1000
byte messages, set a minimum nvqueuemaxsize of 4032.
nvqueuetrace Non-volatile (NV) queueing subsystem trace level (0-4), for
Support purposes. Leave as 1 (default).
teletrace Data connection subsystem trace level (0-4), for Support purposes.
Leave as 1 (default).
update_autoreboot ETM will automatically reboot after an OTA update is processed,
either:
0 – automatic reboot disabled
If you disable this parameter, the
+ETM:REBOOTREQUIREDURC will appear after an
update, requiring the host to tell ETM when to reboot. To
apply the changes, the host must reset ETM as soon as
possible by sending AT+ETMSTATE=reboot. If ETM
responds with ERROR: busy the host should try again
shortly.
1 (default) – automatic reboot enabled
If you enable this parameter, ETM will automatically
reboot after an update and issue the
+ETM:REBOOTINGURC. After this, the host must wait for
the +ETM:IDLE URC before starting the desired
telemetry mode.
[network] Network parameters
apn Access Point Name
apnpass APN password
apnuser APN user name
band Comma-separated list of frequency bands, for example:
0xf,0x400a0e189f,0xa0e189f
63
Eseye-enabled Quectel BG96 module Developer Guide v1.8
Using the Quectel BG96 module configuration file