Quectel BG96 - Page 75

Section Parameter Definition
tracelevel MQTT trace level (0-4), for Support purposes. Leave as 1 (default).
urcautoformat For formatting URCs, either:
0 – sends all URCs as ASCII-hex within quotes
For example: '{"key1":"val1"}' will appear in a URC as
'+EMQ:<id>,15\r\n"7B226B657931223A2276616C31227D"'
1 (default) – this option enables sending URCs as either ASCII-hex
or text, depending on the received payload.
•
If the received payload is printable text (including JSON),
then the URC data is sent as text.
For example:
'{"key1":"val1"}' will appear in a URC as
'+EMQ:<id>,15\r\n{"key1":"val1"}'
For JSON, the maximum payload is 1012 characters.
Escaped quotes count as 1 character: \"
•
If the received payload is binary data, then the URC data is
sent as ASCII hex.
[udp] UDP parameters
port UDP IP port. Default: 12401
url UDP IP address
[sms] SMS parameters
enable For configuring SMS handling, either:
0 – SMS handling disabled
1 (default) – SMS handling enabled
tracelevel SMS trace level (0-4), for Support purposes. Leave as 1 (default).
whitelist Comma-separated list of one or more MSISDN values from which
SMS is accepted. For example: 447624499970,447624499971
[location] Location parameters
enable For configuring location, either:
0 (default) – location disabled
1 – location enabled; Quectel BG96 module will always try to
establish a GPS/GNSS location while running
tracelevel Location trace level (0-4), for Support purposes. Leave as 1
Eseye-enabled Quectel BG96 module Developer Guide v1.8
68
Using the Quectel BG96 module configuration file