271
Specific functions of model 0981 Rubino
Filling Timeout
If the boiler filling takes longer than 300 seconds, the machine generates an alarm
with an intermittent acoustic warning and flashing the low water warning light (m).
In this alarm status the boiler heating does not start.
This condition may occur if the machine is switched on for the first time, with the
boiler completely empty.
Switch the machine off, then on again to restart the filling.
If the problem persists, make sure there are no water leakages or clogging in the
hydraulic circuit.
No water in the tank
If the water in the tank drops below minimum level, the machine generates an
alarm with an intermittent acoustic warning flashing the low water warning light
(m).
To exit from alarm condition, it is sufficient to fill the tank.
When the machine is in alarm condition due to lack of water in the tank, the boiler
continues to heat and the water level can be topped-up. This is also possible
when the heating is interrupted due to lack of water in the boiler.
Dosing the coffee if there is no water in the tank
If during coffee delivery there is insufficient water in the tank, the machine only
generates an alarm after the delivery terminates.
Standby (for machines with this function)
The Standby function allows the machine to put itself into a low consumption
condition by switching off the boiler heating element.
The machine automatically switches to Standby after 60 minutes in which no
coffee is made.
When the machine is in Standby, the dedicated LED flashes and to restart the
boiler heater, simply brew a coffee with the lever.
On the left side of the machine's base, there is a switch (p) which when set to
position 1 enables the standby function.
To Next Page
Loading...
Need help?
General
