Issue 1.5 Q-Drive Installation Manual
Copyright © 1996 Quin Systems Ltd. Page 11
3.6 Relevant Directives
This product is designed to be incorporated into a system for the control of
machinery, and needs external equipment to enable it to fulfil this function. It
must not be relied upon to provide safety-critical features such as guarding or
emergency-stop functions. It must not be put into service until the machinery
into which it is incorporated has been declared in conformity with the Machinery
Directive 89/392/EEC and/or its relevant amendments.
The installation instructions in this manual should be followed in constructing a
system which meets requirements.
The product has been tested in typical configurations, and meets the EMC
Directive 89/336/EEC when used with the recommended mains filter.
This product as normally supplied has mains level voltages accessible to touch,
and requires to be mounted within a suitable cabinet to meet any required IP
rating to BSEN 60529.
To Next Page
Loading...