Copyright Notice
Copyright 1996 Quin Systems Limited. All rights reserved.
Reproduction of this document, in part or whole, by any means, without the
prior written consent of Quin Systems Limited is strictly prohibited.
Software Version
This manual reflects the following software versions.
• QDRIVE.EXE version 2.0 or higher.
Important Notice
Quin Systems reserves the right to make changes without notice in the
products described in this document in order to improve design or performance
and for further product development. Examples given are for illustration only,
and no responsibility is assumed for their suitability in particular applications.
Although every attempt has been made to ensure the accuracy of the
information in this document, Quin Systems assumes no liability for inadvertent
errors.
Suggestions for improvements in either the products or the documentation are
welcome.
Relevant Directives
This product is designed to be incorporated into a system for the control of
machinery, and needs external equipment to enable it to fulfil this function. It
must not be relied upon to provide safety-critical features such as guarding or
emergency-stop functions. It must not be put into service until the machinery
into which it is incorporated has been declared in conformity with the Machinery
Directive 89/392/EEC and/or its relevant amendments.
The installation instructions in this manual should be followed in constructing a
system which meets requirements.
The product has been tested in typical configurations, and meets the EMC
Directive 89/336/EEC When used with the recommended mains filter.
This product as normally supplied has mains level voltages accessible to touch,
and requires to be mounted within a suitable cabinet to meet any required IP
rating to BSEN 60529.
To Next Page
Loading...
General