Rabbit Smartcat - Keypad

User’s Manual 109
C.8.3 Keypad
The functions used to control the keypad are contained in the located in the Dynamic C
KEYPADS\KEYPAD7.LIB library folder.
Initializes keypad process
RETURN VALUE
None.
SEE ALSO
brdInit
Assigns each key with key press and release codes, and hold and repeat ticks for auto repeat and
debouncing.
PARAMETERS
cRaw is a raw key code index.
1x7 keypad matrix with raw key code index assignments (in brackets):
User Keypad Interface
cPress is a key press code
An 8-bit value is returned when a key is pressed.
0 = Unused.
See keypadDef() for default press codes.
cRelease is a key release code.
An 8-bit value is returned when a key is pressed.
0 = Unused.
cCntHold is a hold tick, which is approximately one debounce period or 5 µs.
How long to hold before repeating.
0 = No Repeat.
cSpdLo is a low-speed repeat tick, which is approximately one debounce period or 5 µs.
How many times to repeat.
0 = None.
cCntLo is a low-speed hold tick, which is approximately one debounce period or 5 µs.
How long to hold before going to high-speed repeat.
0 = Slow Only.
void keyInit(void);
void keyConfig(char cRaw, char cPress,
char cRelease, char cCntHold, char cSpdLo,
char cCntLo, char cSpdHi);
[0] [1] [2] [3]
[4] [5] [6]