Rabbit Smartcat - BL2100 Function APIs; Board Initialization

42 Smartcat (BL2100)
4.4 BL2100 Function APIs
4.4.1 Board Initialization
Call this function at the beginning of your program. This function initializes the system I/O ports and
loads all the A/D converter and D/A converter calibration constants from flash memory into SRAM for
use by your program. If the LCD/keypad module is installed, this function will turn off LED DS1 to indi-
cate that the initialization was successful.
The ports are initialized according to Table A-3.
SEE ALSO
digOut, digIn, serMode, anaOut, anaIn, anaInDriver, anaOutDriver
void brdInit (void);