User’s Manual 119
APPENDIX E. DEMONSTRATION BOARD
Appendix E shows how to connect the Demonstration Board to
the BL2100.
E.1 Connecting Demonstration Board
Before running sample programs based on the Demonstration Board, you will have to con-
nect the Demonstration Board
from the BL2100 Tool Kit to the BL2100 board. Proceed as
follows.
1. Use the wires included in the
BL2100 Tool
Kit to connect header J1 on the Demonstra-
tion
Board to screw-terminal headers J5 and J8 on the BL2100. The connections are
shown in Figure E-1
for sample program DIGIN.C and for sample program SMTP.C, in
Figure E-2
for sample program DIGOUT.C, and in
Figure E-3
for sample program
SSI.C.
2. Make sure that your BL2100 is connected to your PC and that the power supply is con-
nected to the BL2100 and plugged in as described in Chapter 2, “Getting Started.”
To Next Page
Loading...
