56 Smartcat (BL2100)
The PC running Dynamic C through the serial programming port on the BL2100 does not
need to be the PC with the Ethernet card.
3. Apply Power
Plug in the AC adapter. The BL2100 is now ready to be used.
NOTE: A hardware RESET is accomplished by unplugging the AC adapter, then plug-
ging it back in, or by momentarily grounding the board reset input at pin 9 on screw-
terminal header J2.
When working with the BL2100, the green LNK light is on when a program is running and
the board is properly connected either to an Ethernet hub or to an active Ethernet card. The
orange ACT light flashes each time a packet is received.
To Next Page
Loading...
