RACOM RipEX - Page 70

SPEED – enables the two highest Data rates for 50 and 25 kHz channel spacings
(Part No. RipEX-SW-SPEED)
COM2 – enables the second serial interface configurable as RS232 or RS485
(Part No. RipEX-SW-COM2)
10W – enables RF output power 10 W for CPSK modulations
(Part No. RipEX-SW-10W)
BACKUP
ROUTES
– enables Backup routes
(Part No. RipEX-SW-BACKUP ROUTES)
MASTER – enables all functionalities of all possible SW feature keys
(Part No. RipEX-SW-MASTER)
Software keys are always tied to a specific RipEX Serial number (S/N). When SW key is ordered later
and not together with RipEX unit, this S/N must be given.
Ex feature key
Ex – authorization for use in hazardous location
II 3G Ex ic IIC T4 Gc
Ex key is always tied to a specific RipEX Serial number (S/N). When Ex key is ordered later and not
together with RipEX unit, this S/N must be given. Ex keys are available only for units produced after
1st of January 2014.
Important
Since SW feature key can be activated anytime within RipEX, it is not a part of the Code.
Standard RipEX package in paper box contents:
• RipEX – 1pc
• Removable sticker plate – 1pc
• Power and Control plug connector (counterpart) – 1pc
• DIN set (a pair of DIN rail clips + screws) – 1pc
Accessories
Power supplies
PWS-AC/DC-AD-155A – Power supply with back-up 90–260 VAC/13.8 VDC/150 W
PWS-AC/DC-DR-75-12 – Power supply 85–264 VAC/12 VDC/75 W DIN
PWS-AC/DC-MS2000/12 – Power supply with back-up 230 VAC/13.8 VDC/70 W
PWS-SOLAR-MSU120 – Power supply for solar panel 12 VDC 50–120 W /10.5–14.7 VDC
BAT-12V/5Ah – Battery 12 V, 5.0 Ah (for RipEX_DEMO_CASE)
BAT-12V/7.2Ah – Battery 12 V, 7.2 Ah (for RipEX-HSB)
Holders
RipEX_F_BRACKET – Flat-bracket, for flat mounting
RipEX_L_BRACKET – L-bracket, for vertical mounting
19‘ rack mounting
RipEX_D_RACK_230 – 19" rack shelf double, incl. 2× PS 100–256 VAC / 24 VDC
RipEX Radio modem & Router – © RACOM s.r.o.70
Product