4.6. Accessories
1. RipEX Hot Standby
RipEX-HS is redundant hot standby chassis. There are two hot-stand-by standard RipEX units
inside. In case of a detection of failure, automatic switchover between RipEX units sis performed.
RipEX-HS is suitable for Central sites, Repeaters or Important remote sites where no single point
of failure is required.
Fig. 4.16: RipEX-HS
Fig. 4.17: RipEX-HS dimensions
For more information see RipEX-HS datasheet or User manual on www.racom.eu
1
.
2. ETH/USB adapter
Fig. 4.18: Adapter ETH/USB
ETH/USB adapter for service access to the
web interface via USB connector. Includes a
built-in DHCP server which provides up to 5
leases. To access the RipEX always use the
fixed IP 10.9.8.7. For details on use see Sec-
tion 5.3, “Connecting RipEX to a programming
PC”.
OTH-XA-ETH/USB requires FW 1.7.1.0 or
higher. The previous model OTH-X5-ETH/USB
is supported in all FW versions.
1
http://www.racom.eu
RipEX Radio modem & Router – © RACOM s.r.o.72
Product
To Next Page
Loading...
