29
'Disinfection Status'
This shows the status of the disinfection cycle.
'Disinfection Control'
The controls for the 'Disinfection Cycle'.
'Disinfection Setup'
The controls that enable a 'Disinfection Cycle' to be run and sets the 'Disinfection
Timeout' feature.
1.
Click 'Enable Disinfection' checkbox and set the 'Disinfection Timeout' value
'Disinfection Timeout' is the number of minutes the temperature alert and
error displays are disabled to allow for disinfection and cool down of the blend
circuit before switching back on automatically, i.e. if 'Disinfection Timeout'
is set to 30 minutes then the DRV40 has that amount of time to complete the
disinfection and cool down before entering an error condition and switching to
full cold.
Please note the following:
• 'Disinfection Timeout' starts when Trigger is pressed.
• During the 'Disinfection Timeout' the disinfection and cool down must
be completed manually and the DRV40 returned to 'Setpoint' (normal
operation within the setpoint limits).
To Next Page
Loading...
Need help?
General
