Radio Shack 20-427 PRO-2054 - Scanning the Channels

22
T
h
e Basics
scanning the channels
To begin scanning channels or to start scanning
again after monitoring a specifi c channel, press
SCAN
.
You must store frequencies into channels
before the scanner can scan them. The scanner
does not scan through empty channels.
To change the scanning direction, press

or

.
The scanner scans through all channels (except
those you have locked out) in the active banks
(see “Turning Channel-Storage Banks Off and On”
and “Locking Out Channels or Frequencies”).
You must store frequencies into channels
before the scanner can scan them. The scanner
does not scan through empty channels.
NOTES