Radio Shack 20-427 PRO-2054 - Scanner Care and Cloning

45
Beyond the Basics
1. If the scanner is on, turn
OFF
/
VOL
counterclockwise until it clicks to turn the
scanner off.
2. Turn
OFF
/
VOL
clockwise to turn the scanner on.
VOL clockwise to turn the scanner on. VOL
WELCOME
appears.
3. While
WELCOME
appears, press
1
to turn on
the key tone or
2
to turn it off.
using the dimmer
Repeatedly press
DIM
to adjust the brightness of
the display backlight to Dark, Light Off, or Light.
cloning the programmed data
You can transfer the programmed data to and
from another PRO-2054 scanner using an optional
connecting cable with 1/8-inch (3.5mm) phone
plugs on both ends (not supplied, available online
at
www.radioshack.com
).
1. Turn on both scanners.
2. Connect the connecting cable to each
scanner’s PC/IF jack.
CLOnE
and
UP to SEnd
appear.
3. Press

at the host scanner.
4.
SEndInG
appears at the host scanner.
The scanner sends the data. To exit the clone
mode, remove the cable.
CLOnE
and
Error
may alternately appear when the
scanner receives data from a scanner other than
a PRO-2054. If this happens when the scanner
receives data from another PRO-2054, turn off the
scanner and then turn it on again.