Radio Shack 20-427 PRO-2054 - Using Signal Stalker II

37
Beyond the Basics
Once an active frequency is found, the
transmission is played through your scanner’s
speaker, and you can quickly store it in any of
your scanner’s memory locations.
using signal stalker II
Your scanner’s Signal Stalker II functions when
you press and hold
SCAN
/
for approximately 1
for approximately 1
second. The Signal Stalker II function can be set
to watch for activity on all band frequencies or
Police/Fire FRS frequencies only. To change the all
bands to police/fi re or vice versa, press
FUNC
and
then
.
You can also turn on/off frequency sub-bands
using the corresponding number keys while
Signal Stalker II is active.
Priority mode is not available while using the
Signal Stalker II.
Press
FUNC
and then

. You can now change the
normal Signal Stalker II operation to the Special
Signal Stalker II operation. In the Special Stalker
operation,
fl ashes and the frequency range
fl ashes and the frequency range
is divided by 1 MHz segments. If you lock out 5
frequencies within a 1 MHz segment, the scanner
will skip that segment in subsequent sweeps. See
“Using Signal Stalker II with Lockout” below.
If the scanner has more than 5 locked out
frequencies in each frequency segment, ALL
Fr-IGno appears and the scanner does not
operate the stalker function.
Signal Stalker II is active.
Priority mode is not available while using the
Signal Stalker II.
Press
FUNC
NOTE
If the scanner has more than 5 locked out
frequencies in each frequency segment, ALL
Fr-IGno appears and the scanner does not
NOTE