tuned frequency in the display. Because steps
are so close together, the audio quality will not
be affected by the offset.
To turn off banks while scanning, press the bank’s
number key so the bar below the bank’s number
disappears. For example, to turn off bank 1, press
. The scanner does not scan any of the channels
within the banks you turned off.
To turn on banks while scanning, press the
number key until the bank’s number appears. For
example to turn bank 1 on again, press
You cannot turn off all banks. There must be at
You can manually select any channel in a bank,
even if the bank is turned off.
You cannot turn off all banks. There must be at
You can manually select any channel in a bank,
To Next Page
Loading...
