Radio Shack 20-427 PRO-2054 - Delay and Lockout Functions

39
Beyond the Basics
Signal Stalker II features a special lockout
mode that causes the scanner to skip a 1 MHz
segment if fi ve or more lockouts exist in that
1 MHz segment. To activate this mode, press
FUNC

while in the Signal Stalker II mode. If a
1 MHz segment contains 5 or more lockouts it
will be skipped entirely while Signal Stalker II is
sweeping. Use
FUNC
L/OUT
to review or clear locked
Signal Stalker II frequencies.
To clear a locked out frequency, select that
frequency, then press
CLEAR
.
using delay
Many conversations might have a pause of
several seconds between a query and a reply.
To avoid missing a reply, you can program a 2-
second delay into any of your scanner’s channels.
Then, when the scanner stops on the channel,
DLY
appears and the scanner continues to monitor the
channel for 2 seconds after the transmission stops
before it resumes scanning/searching. The delay
feature is also available while searching.
Delay is automatically set as the default for
each channel when you turn on the scanner.
To turn delay on or off, press •/
DELAY
. When delay
is on,
DLY
appears on the display.
DLY appears on the display.DLY
locking out channels or frequencies
You can scan existing channels or search
frequencies faster by locking out channels or
frequencies that have a continuous transmission,
such as a pager channel.
Delay is automatically set as the default for
each channel when you turn on the scanner.
To turn delay on or off, press •/
NOTE