monitoring a single channel
You can monitor a single channel with your
scanner by navigating to that channel while in
manual mode. The scanner will receive traffi c on
deleting frequencies from channels
2. Use the number keys to enter the channel
with the frequency you want to delete.
to enter the program mode.
. The frequency number changes
listening to the marine bank
To listen to the marine bank, press
appears for about 2 seconds, then the scanner
starts searching from marine channel 16.
To stop searching the channels, press
To change the channel manually, press
To search through the marine bank again, press
change the searching direction, press
You can select a marine channel directly. When
the scanner stops searching the marine bank, use
the number keys to enter the two-digit channel
To Next Page
Loading...
