Radio Shack 20-427 PRO-2054 - Initializing Your Scanner

48
Beyond t
h
e Basics
initializing your scanner
Initializing your scanner clears all information
stored in your scanner’s memory. Initialize your
scanner only when you are sure it is not working
properly.
1. Turn off the scanner, then turn it on again.
WELCOME
appears.
2. Press
0
while
WELCOME
appears.
3. Press
1
.
InItIAL
appears on the display.
4. Press
ENT
.
WAIt
appears for about 2 seconds.
CAUTION:
Do not turn off the scanner until the
initialization is complete. When the initialization
is complete, 1CH 000.0000 appears on the
display.
CAUTION:
initialization is complete. When the initialization
is complete, 1CH 000.0000 appears on the
NOTE