NOTE: Default values for device, its code, and time are shown above.Your remote control
settings may be different.
NOTE: If you wish to exit the programming mode at any time, press EXIT once. An
[EXIT] message appears as the remote control returns to normal operation.
NOTE:Ifan [INVALID] message appears, you have inadvertently pressed an incorrect
key. Simply note your error and continue programming.
2. Press ▼ four times until [VOL LOCK] appears.
NOTE:Ifyou go past [VOL LOCK],press ▲ one or more times to return to it.
3. Press SELECT once to begin programming. [TO MODE] appears.
4. Press a mode key (e.g.,
AUDIO) to lock a device’s volume controls to all modes.
[SUCCESS] and then [EXIT SETUP] appear as the remote control automatically
exits the programming mode and returns to normal operation.
5. If desired, repeat steps 1 through 4 as needed to lock volume controls for other
devices to all modes.
PROGRAMMING VOLUME UNLOCK
1. On the remote,press and hold P until the display changes from the default
device and time to
[CODE SET].
2. Press ▼ five times until [VOL UNLOCK] appears.
NOTE:Ifyou go past [VOL UNLOCK],press ▲ one or more times to return to it.
3. Press SELECT once to begin programming. [ALL MODE] appears.
To unlock one mode, skip to step 4.Otherwise press SELECT once to unlock
all modes.
[UNLOCKED] and then [EXIT SETUP] appear as the remote
automatically exits the programming mode and returns to normal operation.
continued on next page...
Changing Volume Lock 23
USER’S GUIDE
(x 5)
(x 4)
To Next Page
Loading...
Need help?
General
