SETTING THE CLOCK
1. On the remote,press and hold P until the display changes from the default
device and time to
[CODE SET].
NOTE: Default values for device, its code, and time are shown above.Your remote control
settings may be different.
NOTE: If you wish to exit the programming mode at any time, press EXIT once. An
[EXIT] message appears as the remote control returns to normal operation.
NOTE:Ifan [INVALID] message appears, you have inadvertently pressed an incorrect
key. Simply note your error and continue programming.
2. Press ▲ four times until [CLOCK SET] appears.
NOTE:Ifyou go past [CLOCK SET],press ▼ one or more times to return to it.
3. Press SELECT once to begin programming. The default setting (12:00 a.m.) or
the current time (if previously set) appears.
4. Press
▲one or more times until the desired hour for morning or evening
(a.m. or p.m.) appears.
5. Press
▼ one or more times until the desired minute appears.
6. Once the time is correctly set,press
SELECT once to accept the values.
The display will confirm your entry with
[SUCCESS] and then [EXIT SETUP].
The remote will return to normal operation.
Setting The Clock 5
USER’S GUIDE
(x 4)
To Next Page
Loading...
Need help?
General
