38 Error Messages/Specifications
8-IN-ONE REMOTE
ERROR MESSAGES
A wrong key sequence or incorrect data has been entered.
Try entry again.
Requested manufacturer’s code has not been found in the
remote’s database.Try another code.
Macro sequence being entered has reached the maximum limit
of 15 keystrokes.Try entry again with fewer keystrokes.
A complete cycle of code search in the remote’s database has
been completed.Try another code search or see our website
www.radioshack.com for help.Or take the remote to your local
RadioShack store.
An error has occurred during a learning or programming
sequence.Try entry again.
Indicates a check result of E2 status is either bad or is not present.
See our website
www.radioshack.com for help or take the
remote to your local RadioShack store.
Indicates data captured during learning has filled the remote’s
memory. Try deleting older learned keys to free up memory
space (see page 22).
Indicates data captured during learning has caused a error in
the remote’s memory. Try learning again.
SPECIFICATIONS
Remote Control Power . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 AAA Batteries
Remote Control Dimensions
(H x W x D). . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9.21 x 2.52 x 1.34 in.
(H x W x D). . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 234 x 64 x 34 mm
Remote Control Weight (without Batteries) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0.45 lb (204 g)
NOTE: Specifications are typical. Individual units might vary. Specifications are subject to change and
improvement without notice.
To Next Page
Loading...
Need help?
General
