20 Searching For Your Code/Using Learning
8-IN-ONE REMOTE
SEARCHING FOR YOUR CODE (continued)
8. Once you have found a working code,press SELECT once to save it. The display
confirms your entry with
[SUCCESS] and then [EXIT SETUP].
The remote returns to normal operation.
NOTE: For future reference, write down the working device code in the appropriate boxes
on page 17.
9. To perform a manual code search for another device,repeat steps 1 through 8,
but this time (in step 5) substitute the appropriate device key for the device
you are searching for.
USING LEARNING
The remote includes a Learning feature so you can add functions that are unique to your
home entertainment devices (e.g.,VCR Tracking Up or Down). However, there are some
considerations:
• Your original remote controls must be in working order for the learning feature to
work properly.
• Learned keys are mode specific, so each one can store a unique function for each mode.
• Learned keys can be used in macros (see
Using Macros on page 24).
• You can also use any key for learning, except device keys,
P,,and POWER.However,
using them as learned keys will overwrite their original functions.
• For optimum learning, avoid high levels of ambient light such as natural sunlight or
energy-efficient fluorescent lights.
NOTE: Please have your original remote controls handy before programming learning. Be sure to
press each key within 5 seconds of the previous entry. If not, the remote will exit
the programming mode.
PROGRAMMING A LEARNING KEY
1. On the remote, press and hold P until the display changes from the default
device and time to
[CODE SET].
NOTE: Default values for device, its code, and time are shown above.Your remote control
settings may be different.
NOTE: If you wish to exit the programming mode at any time, press EXIT once. An
[EXIT] message appears as the remote control returns to normal operation.
NOTE:Ifan [INVALID] message appears, you have inadvertently pressed an incorrect
key. Simply note your error and continue programming.
2. Press ▼ twice until [IR LEARN] appears.
NOTE:Ifyou go past [IR LEARN],press ▲ one or more times to return to it.
(x 2)
To Next Page
Loading...
Need help?
General
