(2) Plug the battery or the radio into the charger. Make sure the battery terminals are good in contact with charging terminals. The indicator
light turns to red--- charging begins.
(3) It takes approximately 2-5 hours to fully charge the battery. When the lamp lights green, the charging is completed. Remove the battery or
the radio unit with its battery from socket
NOTICE
when charging a radio (with battery) the indicating lamp will not turn into green to show the fully charged status if the radio is powered on.
Only when the radio is switched off will the lamp indicate normal operation. The radio consumes energy when it is power-on, and the
charger cannot detect the correct battery voltage when the battery has been fully charged. So the charger will charge the battery in constant
voltage mode and fail to indicate correctly when the battery has been fully charged.
(4) LED Indicator
Red LED Green LED Status
Flashing Steady
Standby (charger empty)
Error (charger with radio)
Steady Off Charging
Off Steady Charge complete.
The charger and battery are fitted with matching notches so that you can charge your battery on its own! Practical if you have two batteries.
That way you can charge one battery while still using your radio.
Radio should be turned OFF during charge cycle.
2.5 Using the Type-C Charger
The Type-C charger is a handy port that allows you to conveniently charge your Li-on battery pack.
(1) Make sure your radio is turned OFF.
(2) Plug the Type-C cable into the Type-C charging port on your battery. Connect the other end of the Type-C charger to wall power outlet.
(3) An empty battery will be fully charged in 6 hours.
(4) The battery meter on LCD will move to indicate the battery is charging.
2.6 Battery Maintenance
The battery for your radio comes uncharged from the factory; please let it charge for at least four to five hours before you start using your
radio.
• Use only batteries approved by the original manufacturer.
To Next Page
Loading...
