ON
Disables the [PTT] button on a channel that is already in use.
The transceiver will sound a beep tone and will not transmit if the
[PTT] button is pressed when a channel is already in use.
16 OffSet Specifies the difference between the TX and RX frequencies
17 Direction
None
TX = RX (simplex). Disable access to repeaters in VFO/Frequency
mode
Plus
Plus frequency shift direction. TX will be shifted higher in
frequency than RX
Minus
Minus frequency shift direction. TX will be shifted lower in
frequency than RX
16 CH_Memory CH001-CH100
This menu is used to either create new or modify existing
channels (1 through 100) so that they can be accessed from
MR/Channel Mode.
17 CH_Delete CH001-CH100
This menu is used to delete the programmed information from
the specified channel (1 through 100) so that it can either be
programmed again or be left empty.
6
Radio
Info
Radio ID\Firmware\Hardware
Displays radio ID, firmware version, hardware version. to check
the radio information.
Appendix D. - DCS Table
DCS CODE LIST
Number Code Number Code Number Code Number Code Number Code
1 D023N 2 D025N 3 D026N 4 D031N 5 D032N
6 D036N 7 D043N 8 D047N 9 D051N 10 D053N
11 D054N 12 D065N 13 D071N 14 D072N 15 D073N
16 D074N 17 D114N 18 D115N 19 D116N 20 D122N
21 D125N 22 D131N 23 D132N 24 D134N 25 D143N
26 D145N 27 D152N 28 D155N 29 D156N 30 D162N
31 D165N 32 D172N 33 D174N 34 D205N 35 D212N
36 D223N 37 D225N 38 D226N 39 D243N 40 D244N
41 D245N 42 D246N 43 D251N 44 D252N 45 D255N
To Next Page
Loading...
