(17) Channel Delete (CH-Delete) – MENU +17
This menu is used to delete the programmed information from the specified channel (1 through 100) so that it can either be programmed again
or be left empty.
* Differences in menus in frequency mode
(14) Frequency offset (Offset) – MENU + 14
In this menu you can set the deviation between tx and rx. The frequency offset of this radio is 00.000-99.998MHz.
(15) Frequency offset direction (Direction) – MENU + 15
Using this function, you can set the direction of the frequency offset in rx and tx.
You ha ve the following options:
• OFF: No offset.
• Plus: Positive offset(+);
• Minus: Negative offset(-);
7.6 Radio Info
Show the Radio ID, firmware version, Hardware version.
To Next Page
Loading...
