Allows setting CTCSS/DCS code in RX/TX CTCSS/DCS menu.
The encryption icon
will be displayed on the screen when the encryption function is turned on.
(11) Signal code (Signaling) – MENU +11
Selects 1 of 20 DTMF codes. The DTMF codes are programmed with software and are up to 3 digits each.
(12) Working Mode (CH-MDF) – MENU +12
This function is used to set the display mode of the current channel. The radio offers three working modes:
• NAME: Channel name
• FREQ: Frequency Mode
• CH: Channel Mode
NOTE: The channel name allows editing via the CPS programming software and the channel Name in the Program Channel.
(13) Monitor (SP-MUTE) – MENU +13
With this function, the monitor opens if one of these options is detected:
• QT: When radios is set in this mode, the monitor feature is activated only when the radio receives the correct CTCSS tones.
• QT*DTMF: The monitor is activated when the radio receives the correct CTCSS tone or the correct DTMF code.
(14) Scan Add (Scan Add) – MENU+14
In channel mode, to scan the current channel, the channel must be added to the scan group.
• On: Turn on the scan function of the current channel.
• Off: Do not scan the current channel.
(15) Busy Channel Lock (Busy Lock) – MENU+15
When this function is on, it may prevent other radios’ interference. If the selected channel is being used by other radios, when you press key
PTT, your radio cannot transmit.
Release the PTT and transmit as soon as the frequency is no longer busy.
(16) Channel Memory - (CH-Memory) – MENU +16
This menu is used to either create new or modify existing channels (1 through 100) so that they can be accessed from MR/Channel Mode.
The channels already stored are displayed as CH-XXX ("CH" and -channel number), and other channels only display channel numbers.
To Next Page
Loading...
