• Press to automatically search a radio station.
(3) Press [SK1] key to exit FM radio.
Note: while you are listening to the radio, the frequency or channel of A / B receiving signal will automatically switch to the frequency or
channel mode for normal transmitting and receiving.
When the signal disappears the radio will automatically switch again to FM radio mode.
5.11 Monitor
In standby, press and hold the [SK2] key to enter Monitor. When receiving matched carrier but the signaling or the signal is too weak, this
function allows monitor the weak signal.
Stop pressing the [SK2] key to turn off the speakers and return to standby mode.
» If no signal, it will emit noise when press the [SK2] Key.
5.12 Keypad lock
The radio features a keypad lock that locks out all keys except for the three side keys.
To enable or disable the keypad lock, press and hold
the key for about two seconds.
You can also enable so that the radio automatically locks the keypad after ten seconds from the menu.
5.13 TX Repeaters tone
Press [PTT] + [SK2] key to send 1750Hz repeaters tone. This function is useful for communications through repeaters.
If you have the keypad lock enabled on your radio, you can still send a 1750Hz tone the regular way without having to unlock your radio.
5.14 Weather Radio/Scan Weather Channel
Your radio has a NOAA Weather Radio function, to enable the user to receive weather reports from designated NOAA stations. Your radio also
has a NOAA Weather Scan function, to enable the user to scan all 10 channels of the NOAA Weather Radio.
(1) To turn the NOAA Weather Scan on, press and hold the
key for 3 seconds , icon appears. The radio will go to Weather band
mode.
(2) Press and hold the
key for 3 seconds to start automatic scanning of all 10 channels and stop on active channels. Pressing and holding
the
key for 3 seconds during a NOAA weather scan will stop the scan.
To Next Page
Loading...
