(5) After finding the desired next menu item, press the [MENU] key again to select the menu item.
(6) Use the or keys to select the desired parameter.
(7) When you have selected the parameter to be set for a given menu item;
(8) To confirm your selection, press [MENU] and it will save your setting and bring you back to the main menu.
(9) To cancel your changes, press [EXIT] and it will reset that menu item and bring you out of the menu entirely.
(10) To exit out of the menu at any time, press the PTT key.
7.2 Using short-cuts
As you may have noticed if you looked at Appendix C, Menu definitions, every menu item has a numerical value associated with it. These
numbers can be used for direct access of any given menu item.
Using the menu with short-cuts
(1) Press the [MENU] key to enter the menu.
(2) Use the numerical keypad to enter the number of the menu item.
(3) To enter the menu item, press [MENU] the key.
(4) For entering the desired parameter you have two options:
a) Use the arrow keys as we did in the previous section; or
b) Use the numerical keypad to enter the numerical short-cut code.
(5) And just as in the previous section;
a) To confirm your selection, press and it will save your setting and bring you back to the main menu.
b) To cancel your changes, press and it will reset that menu item and bring you out of the menu entirely.
(6) To exit out of the menu at any time, press the key.
(7) All further examples and procedures in this manual will use the numerical menu short-cuts.
[MENU] + 1: Quick access to Banks selection, up to 10 banks are stored, each bank stores 100 channels;
[MENU] + 2: Quickly enter the Scan Settings. You will be able to set the VFO frequency range, Scan mode, Scan Sub-Code, Scan Memory;
[MENU] + 3: Quickly enter the Radio settings (general settings of the radio);
[MENU] + 4: Quickly enter GNSS position system settings (GNSS switch, time zone setting, position mode setting)
[MENU] + 5: Quick access to Program Channel (Alias, TX and RX Frequency, TX Power, Bandwidth, Display mode, Channel Memory and Channel
delete);
To Next Page
Loading...
