RadioLink AT9S PRO - 2.3 AIRPLANE BASIC FUNCTION; 2.3.1 Model Select; Model Name; COPY

Radiolink Electronic Ltd
www.radiolink.com
14
2.3 AIRPLANE BASIC FUNCTION
2.3.1 Model Select
Model submenu: includes three function that manage model
memory: MODEL SELECT,MODELCOPY and MODEL NAME.
Since these functions are related, and all basic features are used
with most models, they are together in the Model submenu.
MODEL SELECT
Totally there are 15 models stored in the system, followed by model name and plane type to use on tap,
thus you don’t need to set every time for different plane. MODEL NAME, MODEL TYPE and transmitter
voltage. Make sure that MODEL TYPE is accomplished with your plane type before flight. Or it will cause error
in servo and rudder.
COPY
Save the present data as another model type, it will be displayed by shadow area to differ from. When this
copy start, the object data will be fully covered including name, type and module type, and cannot recover.
Caution: when you save the present model type as another, all related data will be copied including the
Activate, assign SWITCH and adjust.
Close the function
to MIX，press ， to INH
to SW，press ， to SwC
to POSI, press ， to DOWN
to RATE ， press ， to down
position， throttle stick down until the
throttle barrel closed
Set up dual/triple rates
and exponential
(D/P,EXP) (Note that in
the middle of the left
side of the screen is
the name of the
channel and the switch
position you are
adjusting. D/R may be
set per channel by
choosing the desired
switch and mix rate.
From BASIC menu, choose the
D/R,EXP
to D/R,EXP，press
Choose the desired control, and set the
first (EX: high) rate throws and
exponential.
SwA to up position A
to CH, press ， to choose CH2，
press
to D/R
Stick down，press ， to
set ,press
Stick up，press , to
set ,press to EXP
Stick up，press to set，press
Stick up，press， to set，press
Set the second(low)rate throws and
exponential.
SwA to down position
to D/R
Repeat steps above to set low rate.