RadioLink AT9S PRO - 2.3.13 TRAINER

Radiolink Electronic Ltd
www.radiolink.com
28
• Also the reset switch can be assigned (SWITCH A-H or LOGIC SWITCH Lsw1-Lsw3)
2.3.13 TRAINER:
For training novice pilots with optional trainer cord connecting 2
transmitters. The instructor has several levels of control.
Adjustability:
• NORM: When the TRAINER SWITCH is ON, the channel set to this
mode can be controlled by the student. The set channel is controlled
according to any programming set at the student's transmitter.
• FUNC: When the TRAINER SWITCH is ON, the channel set to this
mode can be controlled by the student, controlled according to any mixing
set at the instructor's transmitter.
• MIX: When the TRAINER SWITCH is ON, the channel set to this mode can be controlled by both the
student and the instructor, controlled according to any mixing set at the instructor's transmitter. And the
student's mixing rate is adjustable. (Default 30%)
[Note] However, it becomes invalid even if it sets up the channel which is not in a student's transmitter. The
channel serves as operation by the instructor's transmitter automatically.
• OFF: The channel set to this mode cannot be controlled by the student even when the TRAINER SWITCH
is ON. The set channel is controlled by the instructor only, even when the TRAINER SWITCH is ON.
• SWITCH: controlled by spring-loaded SWITCH H only. Not assignable.
• Compatibility: The AT9S Pro may be master or student with any Radiolink transmitter compatible with the
cord. Simply plug the optional trainer cord (For AT9S Pro series, sold separately) into the trainer connection
on each transmitter, and follow the guidelines below.
EXAMPLES:
•When throttle/collective is set to FUNG, 5-channel helicopter practice is possible with a 4-channel
transmitter.
• Set up the model in a second transmitter, use NORM mode to quickly and safely check proper operation of
all functions, and then allow the student radio to fully fly the model.
• Using NORM mode, set lower throws, different exponentials, even different auxiliary channel settings on
the student radio (if it has these features).
Set timer 2 to count
down 4 1/2 minutes,
being controlled by
Throttle Stick position.
This utilized to keep
track of actual Throttle
on time to better
cooperate with
fuel/battery usage.
Open BASIC menu, then to
TIMER
for 1s .(If ADVANCE again) .
to TIMER ,PUSH
Go to TIMER <2>
to TIMER <2> ，PUSH
Adjust time to 4min.30sec.,
count down
to 4,PUSH.
to 00 TIMER<2>，PUSH to 30,PUSH
Assign switch at ST-THK and
set trigger point.
to SWA TIMER<2>，， to ST-THK，PUSH
Throttle Stick down to 50%,PUSH for 1s to
NULL.
Throttle Stick down to desired position(Ex:1/4
stick) PUSH button for 1s to set.
Close
【TRAINR】
MIX: INH
1：AILE FUNC
2：ELEV FUNC
3：THRO FUNC
4：RUDD FUNC
5：GEAR FUNC
6：FLAP FUNC
7：AUX1 FUNC
8：AUX2 FUNC