RadioLink AT9S PRO - 4.3.13 FLAP-TRIM (see GLID 3.3.4); 4.3.14 CONDITION

Radiolink Electronic Ltd
www.radiolink.com
55
Adjustability:
• Delay time (-DLY-) range of 0 to 100%. The delay time is 10 second at 100%.
Goals
Steps
Inputs
Ex: delay time=5
second.
Open ADVANCE menu,
then open START DELAY.
to BASIC . again to ADVANCE
to START-DLY,
Activate the function
to MIX ， to OFF or ON
Set the delay time.
(Ex:50% each surface)
to ELEV ， to 50%
to RUDD ， to 50%
Repeat as needed.
Close
4.3.6 CHAMBER-FLP
CAMBER FLAP assigns the primary flap control [defaults to VR (A)] to allow trimming in flight of the flap
action. The up and down travel of each flap (camber flaps: FLP1/2) can be adjusted independently. Also the
center position of flap servo can be offset.
Note: If FLAP-TRIM is activated, you can not use CAMBER
FLAP function simultaneously.
Adjustability
• Rate: -100% to +100%, with a default of +30%
• Center position (CENTER): The operation reference point of flap
can be offset. -100% to +100%, with a default of 0%.
Note: When changing the polarity of a rate, "change rate dir?"
is displayed for a check. Please set up after pressing DIAL for 1
second and canceling an alarm display.
Goals
Steps
Inputs
Ex: Set the maximum
travel of 35% of the
total flap travel.
Open the CAMBER FLAP
function.
to BASIC . again to ADVANCE
to CAMBER-FLP,
Adjust the up/down trim
amount separately.(Ex:
adjust to 35%)
to FLP 。
VR (A)， to 35%，
VR (A)， to 35%， 。
Repeat.
Or: adjust the center position
of flap servo
to CENTER ， to desired point.
Close