RadioLink AT9S PRO - 5.2 HELI-SPECIFIC BASIC MENU FUNCTIONS; 5.2.1 Swash Plate Types; 5.2.2 SWASH AFR (not in SWH1)

Radiolink Electronic Ltd
www.radiolink.com
63
to be used. Before doing anything else to set up your model, first you must decide which MODEL TYPE best
fits your MULTIROTOR.
HELICOPTER SWASHPLATE TYPES:
The AT9 radios support 8 basic swash plate setups, including "single servo" (H-1-most helicopters use this
type) and 7 types of CCPM (cyclic and collective pitch mixing). A "single servo" swash plate uses one servo
for each axis: aileron, elevator (cyclic pitch), and collective pitch. CCPM helicopters utilize a combination of
servos working together to achieve the 3 axes of motion. There are 7 basic CCPM types, displayed below.
CCPM has several advantages, the most obvious of which is far less mechanical complexity to properly move
the swash plate of the helicopter. Additionally, several servos working in unison (ex: HR3, all 3 servos
together create elevator movement) dramatically increases the torque available as well as the precision and
centering.
Please note that some helicopters are type HR3 or HN3, except off by 180 degrees. If your model 's swash
plate is off by 180 you will still use that swash plate type, but also use SWASH AFR to adjust the functions as
needed until it operates properly. Additionally, different angles of CCPM may also be created utilizing the fully
assignable programmable mixes.
5.2.1 Swash Plate Types
Goals
Steps
Inputs
Change the model
type and
swashplate of
model#3 from
MULTIROTOR to
120 degree CCPM
with 2 servos
working in unison
for collective pitch
and aileron (Ex:
HELI HR3)
Confirm you are using
the proper model
memory(Ex:3)
On home screen, check model name and # on top left. If
it is not the correct model (Ex:3) see MODEL SEL.
Open PARAMETER,
go to MODEL SEL.
for 1s to BASIC.(If ADVANCE again) .
to MODEL SEL.
Select proper MODEL
TYPE
(HELICOPTER)
Confirm
to TYPE. ， to HELICOPTER. for 1sec. ‘Are
you sure?’ Displays.
Change to desired
SWASH TYPE (Ex:
HR3) Confirm.
to SWASH. ， to HR3，
for 1 sec. ‘Are you
sure?’ displays.
Close