Radiolink Electronic Ltd
www.radiolink.com
4.3.9 AILE/ RUDD MIX
You can select a pre-programmed mix which is used to mix the
rudders with aileron operation or the ailerons with rudder operation.
Aileron-to-rudder mix (AILE RUDD): automatically creates a
"coordinated turn".
Rudder -to-aileron mix (RUDD AILE): used to counteract undesirable
roll (roll coupling) that happens with rudder input, especially in
knife-edge.
Adjustability:
• RATE range of -100 to +100. Negative setting would result in opposite rudder (aileron) action from aileron
(rudder).
• SWITCH A-H fully assignable. Also LOGIC SW (Lsw1 to 3) may be assigned.
• POSITION fully assignable, including NULL (mix always on) and Up&Cntr and Cntr&Dn to activate the mix in
2 separate positions of the same SWITCH.
• Condition: The separate AILE RUDD setting for each flight condition can be set.
Ex:RUDD-AILE,2
5%,no switch,
corrects roll
coupling.
Open AIL/RUD-MIX
submenu.
to BASIC . again to ADVANCE
to AIL/RUD-MIX,
Set the rate (Ex:100%
each way)
to RATE
RUDDER STICK ， to +25%
RUDDER STICK ， to +25%
4.3.10
ELEV-FLAP mixing (see GLID menu 3.3.7)
4.3.11 AILE-FLAP(GLID 2A+2F only):
This pre-programmed mix is used to create full span aileron action on a glider
with 4wing servos. This increases the roll rate and decreases induced drag. For normal flying, a value of
about 50% is often used. For slope racing or F3B models in speed runs, you may wish to use a larger value
approaching 100%.
Adjustability:
• RATE range of -100 to +100. Negative setting would result in opposite aileron action from flaps.
• SWITCH A-H fully assignable. Also LOGIC SW (Lsw1 to 3) may be assigned.
• POSITION fully assignable, including NULL (mix always on) and Up&Cntr and Cntr&Dn to activate the mix in
2 separate positions of the same SWITCH.
• Condition: The separate AILE-FLAP settings for each flight condition can be set.
To Next Page
Loading...
