RadioLink AT9S PRO - Spoiler MIX (GLID)

Radiolink Electronic Ltd
www.radiolink.com
59
Goals
Steps
Inputs
Turn on AILE-FLAP
mixing. Set rate to
100% for maximum
possible flap travel
with ailerons .Assign
to SWITCH C center.
Open AILE-FLAP submenu.
to BASIC . again to ADVANCE
to AILE-FLAP,
Activate the function
to MIX ， to ON
Set the rate (Ex:100% each
way)
to FLP1
AILERON STICK ， to 100%
AILERON STICK ， to 100%
Repeat above to set FLP2
Assign the SWITCH and
position.
to SW ， to SwC
to POSI ， to UP
Close
4.3.12 SPOILER MIX (GLID):
Moves the spoiler by flipping the assigned switch and is used to
make steep decent. SPOILER MIX works linking with BUTTERFLY
MIX.
Adjustability:
• Position: -100% to +100%, with a default of -50% (off), +50% (on)
• Channel: Spoiler 1: ch8, or 3 (ch8 or 3*), Spoiler 2: NULL, or 3
(NULL or ch3*) *GLID (2A+2F) mode.
• Elevator setting: Rate: -100% to +100%, Delay: 0% to 100%
• SWITCH A-H fully assignable. Also LOGIC SW (Lsw1 to 3) may be assigned.
Goals
Steps
Inputs
2-servo spoiler
mode. Adjust the
spoiler servo position
to 60%
Open the SPOILER MIX
function and move to 2
nd
page.
to BASIC . again to ADVANCE
to SPOILER - MIX,
Activate the function.
to MIX ， to ON.
Assign the SPO2-CH.(Ex:
CH3)
to –SPO2- CH ， to CH3，
Adjust the spoiler servo
position. (Ex:
SPO1/SPO2=+55% to
+60%)
to –SPO1-POSI to -50%, ， to 60%,
to –SPO2-POSI to +50%, ， to 60%,
Optional: Set the elevator
rate.(Ex:10%)
to –rate- ELEV ， to 10%，
Optional: set the delay.
(Ex:25%)
to –dly- ELEV ， to 25%，
Close