RadioLink AT9S PRO - Camber Mixing; Butterfly (Crow) Mixing

Radiolink Electronic Ltd
www.radiolink.com
56
4.3.7 Camber Mixing:
This function adjusts the mixing rate of camber operation which
operates the wing camber (ailerons and flaps) in the negative and
positive directions. The aileron, flap, and elevator rates can also be
adjusted independently and attitude changes caused by camber
operation can be corrected.
Also the operation reference point of camber control can be offset.
(PRE)
Note:
Camber control is not assigned at initial.
Adjustability:
• Rate: -100% to +100%, with a default of +30%
• Reference point (PRE): The operation reference point of camber control can be offset. -100% to +100%,
with a default of 0%.
4.3.8 BUTTERFLY (crow) mixing
BUTTERFLY simultaneously moves the flaps, twin ailerons and elevator, and is usually used to make steep
descents or to limit increases in airspeed in dives. Separate two BUTTERFLY settings are available.
(CRI1/CRI2)
Adjustability:
• Activation: Get proportional by moving the THROTTLE STICK.
Goals
Steps
Inputs
Ex: set the mixing
amount for aileron
to 40%, camber
control to VR (E),
reference point to
desired point.
Open the CAMBER MIX
function.
to BASIC . again to ADVANCE
to CAMBER-MIX,
Choose desired slider.
to VR ， to VrA
Adjust the mixing amount for
AILE. (Ex: adjust to 40%)
to FLP
to VrA ， to 40%,
to VrA ， to 40%，
Set the reference point.
to PRE ， or VrA to desired
point for 1 sec.
Close