EasyManua.ls Logo

RadioLink AT9S PRO - 3.3.8 Dual Elevator Servos (with a rudder) (AILEVATOR) (ACRO)

RadioLink AT9S PRO
83 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Radiolink Electronic Ltd
www.radiolink.com
40
traveled as FLAPERON/SPOILERON by changing the Flap Trim travel.
Goals
Steps
Inputs
Add FLAP-TRIM to allow
the model’s ailerons to
be trimmed together as
flaps at any time during
the flight, with a
maximum travel of 5% of
the total flap travel set in
FLAPERON.
Open FLAP-TRIM function
to BASIC again to ADVANCE
to FLAP-TRIM.PUSH.
The function is automatically activate with FLAPERON; however the default
travel is 0.
Adjust the travel available to
the FLAPERON when
turning the CH6 dial.
to 5%
Close
3.3.5 AILE DIFF (ACRO/ GLID 2A+1F/ GLID 2A+2F)
ACRO GLID (2A+1F)/GLID (2A+2F)
Aileron differential is primarily used on 3 or 4-servo wings, with one servo operating inboard flap on CH6 or
CH5 & CH6, and AILE-DIFF controlling proper aileron operation of 2 aileron servos, plugged into CH1 and
CH7. The ailerons can not be moved like flaps when using AILE-DIFF, except if using AIRBRAKE. (Note that
even if you make FLAP-TRIM active while using AILE-DIFF, it will not have any effect. ONLY AIRBRAKE
controls the ailerons as flaps in the AILE-DIFF configuration.)
Note: When changing the polarity of a rate in camber-flap, "change rate dir?" is displayed for a check.
Please set up after pressing DIAL for 1 second and canceling an alarm display. (GLID only)
FLAP function allows you to set up 1 or 2 servos for flap action.
• The separate AILE-DIFF settings for each condition can be set. (GLID only)
Goals
Steps
Inputs
Activate twin aileron servos
using AILE-DIFF.
Note that the function
defaults to no difference in
down travel vs. up travel. If
you want differential travel,
simply adjust each side.
(Ex: 90%)
Open the FLAPERON.
to BASIC menu, again to ADVANCE
to AILE-DIFF .PUSH.
Activate the function.
to MIXPUSH. to ACT
Optional: adjust the
up/down travel for 2
servos..(Ex:90% down)
to AILE1 AILERON STICK. to 90%
to AILE2, AILERON STICK to 90%
Close
* If you receive an error message that OTHER WING MIXING IS ON, you must deactivate ELEVON or
FLAPERON.

Table of Contents

Other manuals for RadioLink AT9S PRO

Related product manuals